I'm totally new to this and can't find a solution anywhere about this problem. I'm trying to select faces however it will not select the faces that I want.
I'm wanting to face select both sides of this part to chamfer everything inside it, and deselect all the countersunk holes so it doesn't try to chamfer them again. Is there a way to do this or do I have to select each individual edge...
Is there a way to deselect edges from a face selection in chamfer ...
I get that "face for knurled grip" is one of them, but is that the "source face" or the "target face"? A quick explanation of how Replace Face works might help understand when it succeeds and when it fails. Here is a classic case for Replace: Here, I want to replace the top face of this truncate pyramid with that curvy face.
Hello! I have the following problem: I would like to align an object (the hemisphere in the figure) on top of a face of another object (the selected face in the figure). I tried with Align and Snap Tools but I could not reach my goal. Thanks so much!
I'm new to 3ds max as of today. I need to connect one side of this mesh to the other. How can I select vertices and create faces from them? Like this picture... Thanks for any and all help!
The orientation in a face based family is based on the host, so if you place the family on a wall in the project then the plan presentation set in the family is the front elevation in the project. It is not that hard to figure out once you get used to it.