S10 Generations

S10 Rear end Ring Gear and Axle Sizes: 1983 to 1992 7.5" ring gear 26 spline axles Available from 1988+ 7.625" ring gear 28 spline axles Available from 1995 and up, 8.5" ring gear 30 spline axles, standard for 98+ ZR2's with rear discs These are some of the axle RPO codes and should be the same for all GMs with either of these axles. GU4=3.08 ...

I have a 2003 S10 ZR2 4.3L that I bought just over 2 years ago thats never had heat. I finally got around to replacing the heater core and all that entails with that just to find out that the heater core was fine and working properly, however I found that the plastic arm that connects the big...

I have an 02 s10 4.3 liter that starts then dies, I have a new distributor cap and rotor, crank sensor, fuel pump, fuel filter and coil. it has remote start, no Security light flashing and 60 psi of fuel pressure at the schrader valve. please help im at a loss here, even tried a new key switch...

s10 generations 3

I've searched many forums over the past couple of hours and have found nothing definitive. I'm trying to find accurate measurements of S10 axles, not "I think it's about xx inches wide." I need to know 2WD, 4WD and ZR2 widths from WMS to WMS. A guy has an 8.5 (or 8.625) with G80 from his ZR2...

This post is a compilation of parts, suggestions, tips, and practices to successfully swap an LS-based engine into an S10 Truck (2WD and Blazer variants) Most swappers generally underestimate the total costs and time for these conversions. Keep the engine bay clean. Once the original engine is...

s10 generations 5

i wanna put 20's on my s10 (2000 X w/ belltech 2/3drop) and was wondering if i could just put the rims on with no problems with a 4.75 bs with 245/35/20 tires. I don't know too much about this so any helpful info would be appreciated.

Hey I have a 2001 S10 regular cab 4 banger with a 3/4 djm drop kit(3in Lower control arms and 4in blocks). The truck looks and drives great but i now got into autocross racing and i want to take this truck to the next level. I was thinking to convert to coilovers at all 4 corners and install a 3...

s10 generations 7

1994 Chevy s10 4.3L v6 4x4 Benjamin.mancil 4 56 by Benjamin.mancil S

s10 generations 8